The Snubby Pressure Washer Foam Gun Attachment makes shooting thick
car washing foam with your foam gun manageable and easy for all with a compact
design so you don’t have to use that long and unwieldy pressure washer wand!
Use This To:
- Gain complete control over
- Get rid of that long
pressure washer wand
- Clean those hard to reach
- Effortlessly douse your car
in thick foam
- Get unprecedented freedom
with your foam cannon
- Shoot foam with gas or
electric pressure washers
Compact Design Makes Foaming
Using a pressure washer and
foam cannon is the best way to lay down thick car washing foam, however, that
long pressure washer wand can be difficult to manage and control. They are
long, unwieldy, and risk scratching your paint if you get too close. The Snubby
shoots thick car washing foam with a compact design that keeps your foam cannon
close to you for ultimate control and convenience!
Shoot Thick Car Wash Foam
The ergonomic design of the
Snubby Foam Gun means that you can shoot thick foam without tiring out your
hands. The grippy handle ensures you get a tight yet comfortable grip for
ultimate control over your car wash. The high quality copper components of the
Snubby mean this detailing tool is built to last. Each adapter is wrapped in
Teflon to ensure the tightest seal and minimize leaking for the thickest foam
The Snubby comes with three
adapters to fit your foam cannon and pressure washer. Simply attach the ¼”
female quick release coupler to the Snubby to accommodate any compatible foam
cannon and the 3/8” male quick release connector to your quick release gas or
electric pressure washer to instantly shoot thick foam! Don’t have a quick
release pressure washer? Use the M22 14MM twist and plug adapter to attach the
Snubby to your pressure washer. The Snubby is super versatile, working with
pressure washers up to 5,000 PSI and 10.5 GPM. It even works with water up to
300° F for the ultimate clean!
How To Use It
1. Ensure pressure washer is off.
2. Determine if your pressure washer has a quick release or not.
3. If your pressure has a quick release, attach the ⅜” Male Quick Release
connector to the bottom of the Snubby, then attach to your pressure washer.
4. If your pressure washer does not have a quick release, use the Twist
& Plug Connector to attach the Snubby to your pressure washer.
5. Attach the ¼” female Quick Release Coupler to the Snubby, then attach
your compatible foam cannon.
6. Ensure that foam cannon is securely attached to the Snubby and clicked
in. Point in direction away from vehicle to test.
· If using tip, ensure that it is attached and
clicked in before use. Point in direction away from vehicle to test.
For your pressure washer, different fittings may be necessary (not
included). The Snubby fits pressure washers that are compatible with a
3/8" Male Quick Release Connector or an M22 14mm Twist and Plug Connector.